Best Practices for GoPro Manhole Inspections
Last updated: November 12, 2026
Use steady capture and stop recording promptly to give Sewer3D a clear record of the maintenance hole. Keep the original video until the uploaded inspection and any generated model have been checked.
Before Recording
Check that the lens is clear of dirt, fogging and water droplets.
Plan stable camera positioning so the structure and defects can be seen clearly.
Capture the SewerAI calibration board when possible and take an independent field measurement as a backup. Follow Calibration Board Placement.
Keep the Capture Stable
Keep the camera as steady as possible during the inspection.
Avoid unnecessary movement while capturing the structure.
Remove the camera carefully when capture is complete.
Stop recording shortly after withdrawal, before walking away or replacing the lid.
Extra footage and excessive movement can affect the resulting model. Do not assume that a sideways or distorted model establishes one particular recording error.
Capture Clear Defect Snapshots
In the Video panel, turn on 360 Video. Rotate the view toward the defect and zoom with the mouse wheel or +/− controls before adding the observation. Its snapshot uses that viewpoint. Check the resulting image, especially for defects near the top of the structure.
This zoom instruction is for the PIONEER review viewer, not a GoPro recording setting. The Full Pipe panel is a separate flattened view; its controls differ from 360 Video. Use 3D Model to inspect generated model data.
If you use an existing observation's camera button to replace its snapshot, first seek to the correct video time: that action also sets the observation time to the current playhead. See the timestamp and snapshot guidance.
This is a review-viewpoint step. It does not rescale or repair a 3D model. For model measurement and scaling, follow the point-cloud guide.
If the Model Is Distorted or Incomplete
Review the source video around the affected area.
Note the relevant video times and whether movement, extra footage, poor visibility or an obscured lens is present.
Check the generated model separately and retain the original recording.
Contact Support with the inspection link, affected area and relevant times if the result is still unsuitable.
Support can investigate whether reprocessing is appropriate. Reprocessing is not a guaranteed repair, and a model issue alone does not establish that the inspection must be recorded again.
Eligible Editors and Admins can choose a time range for a new render using Trim for 3D render. A new render can regenerate measurements and pipe connections. Check the eligibility and retention guidance before proceeding. Render-range selection is separate from trimming playback video.
For model availability, progress and the Support contact threshold, use 3D Rendering Troubleshooting.
Still Need Help?
Use the chat widget in PIONEER to contact our support team.
If you cannot access the chat widget, email help@sewerai.com.